JVC rx-558r Manual Do Utilizador

Página de 32
19
English
Adjusting the 3D-PHONIC Modes
Before you start, remember...
• Make sure that you have set the speaker information correctly
(see page 11).
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel:
1. Press SURROUND repeatedly until
“3DACTION” or “3DTHEATR”
appears on the display.
The 3D-PHONIC and PRO LOGIC indicators also light up on
the display.
2. Press ADJUST so that the cursor
control 
% / fi / @ / # buttons work
for adjusting the surround setting.
3. Press cursor control 
% / fi
repeatedly until “–EFFECT+”
appears on the display.
4. Press cursor control 
@ / # to
select an effect level you want.
• Each time you press the button, the effect
level changes as follows:
As the number increases, the selected 3D-PHONIC mode
becomes stronger.
From the remote control:
1. Press SOUND CONTROL.
The 10 keys are activated for sound adjustments.
2. Press SURROUND repeatedly until
“3DACTION” or “3DTHEATR,”
appears on the display.
The 3D-PHONIC and PRO LOGIC indicators also
light up on the display.
3. Press EFFECT to select an effect
level you want.
• Each time you press the button, the effect
level changes as follows:
As the number increases, the selected 3D-PHONIC mode
becomes stronger.
Adjusting the DAP Modes
Before you start, remember...
• Make sure that you have set the speaker information correctly
(see page 11).
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
• You can only adjust the rear speaker output level when you have
connected the rear speakers and have set “REAR SPK” to “YES.”
See page 11.
On the front panel:
1. Press SURROUND repeatedly
until the DAP mode — DANCE
CLUB, LIVE CLUB, HALL, or
PAVILION — appears on the
display.
The DAP indicator also lights up on the display.
2. Press ADJUST so that the cursor
control 
% / fi / @ / # buttons work
for adjusting the DSP setting.
3. Press cursor control 
% / fi
repeatedly until “– REAR +”
appears on the display.
4. Press cursor control 
@ / # to
adjust the rear speaker output
level (from –10 to +10).
Note:
You cannot adjust the left and right rear speaker output levels
separately.
5. Press cursor control 
% / fi
repeatedly until “–EFFECT+”
appears on the display.
6. Press cursor control 
@ / # to
select an effect level you want.
• Each time you press the button, the effect
level changes as follows:
As the number increases, the selected DAP mode becomes
stronger.
SURROUND
ADJUST
SOUND
CONTROL
3
SURROUND
SURROUND
ADJUST
4
EFFECT
5
EFFECT 1
EFFECT 2
EFFECT 4
EFFECT 3
EFFECT 5
EFFECT 1
EFFECT 2
EFFECT 4
EFFECT 3
EFFECT 5
EFFECT 1
EFFECT 2
EFFECT 4
EFFECT 3
EFFECT 5
EN08_22.RX-558R[E]/1
99.1.28, 8:39 PM
19