Toshiba VF-A7 Manual Do Utilizador
21
Figure 3: HyperTerminal Configuration Screen #3
8.2 Telnet
The console is also accessible via a Telnet interface for remote administration over
Ethernet once the unit is communicating on the network. The Telnet console uses
well-known port 23. Note that although only 1 telnet console session can be active at
any given time, the telnet console and RS232 console operate independently and can
be used simultaneously.
Ethernet once the unit is communicating on the network. The Telnet console uses
well-known port 23. Note that although only 1 telnet console session can be active at
any given time, the telnet console and RS232 console operate independently and can
be used simultaneously.
8.2.1 Requirements
All that is needed is a computer with telnet software that can access the ETH-100
over the Ethernet network. Telnet software is typically included as a standard
component of Microsoft Windows and other PC operating systems.
over the Ethernet network. Telnet software is typically included as a standard
component of Microsoft Windows and other PC operating systems.
8.2.2 Connection
No special connections are required, other than the PC running the Telnet application
must be able to logically connect to the ETH-100 to be configured.
must be able to logically connect to the ETH-100 to be configured.
8.2.3 Application Configuration
Although any software vendor’s Telnet client application can be used, the
configuration example given here will use the Microsoft Windows Telnet application.
To start the Telnet application, simply type “telnet” at either a DOS (command)
prompt or in the “Start…Run” window. Once the telnet client screen opens, the
target device can be accessed simply by typing “open” at the Telnet prompt with the
ETH-100’s IP address as an argument. Refer to Figure 4.
configuration example given here will use the Microsoft Windows Telnet application.
To start the Telnet application, simply type “telnet” at either a DOS (command)
prompt or in the “Start…Run” window. Once the telnet client screen opens, the
target device can be accessed simply by typing “open” at the Telnet prompt with the
ETH-100’s IP address as an argument. Refer to Figure 4.