buell s1 lightning '97 Manual
2-35
9.
Install rear shock. See
.
10. Install rear brake caliper assembly. See
REAR BRAKE
CALIPER, INSTALLATION
on
page 2-26
.
11. Install rear wheel. See
REAR WHEEL, INSTALLATION
on
page 2-13
.
12. Install rider footrests. See
13. Install rear fender. See
.
14. Connect and fill lubrication system. See
ENGINE LUBRI-
CATION SYSTEM
in Section 1.
1
WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion resulting in personal injury and/or property damage.
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion resulting in personal injury and/or property damage.
1
CAUTION
Hold battery cable when tightening battery terminal hard-
ware. Failure to hold cable may cause battery damage.
ware. Failure to hold cable may cause battery damage.
15. Connect battery cables, positive cable first.
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
16. Install tail section, fuel tank and seat. See
.
Figure 2-38. Removing Roller Bearing Cups
5702
Figure 2-39. Installing Bearings into Swingarm
Figure 2-40. Adjusting Swingarm Preload
5701
b0250x2x
Acceptable preload is
3.5-5.5 lbs (1.6-2.5 kg)
3.5-5.5 lbs (1.6-2.5 kg)
Pivot Shaft Bearing
Adjuster (Part No. B-41175)