BMW x5 2000 Manual Do Utilizador
70
n
Washer/Wiper system
1 Intermittent wipe or rain
sensor
*
Intermittent wipe:
You can set the wipe interval to four
stages with rotary dial 7.
In addition, the wipe interval is varied
automatically depending on road
speed.
stages with rotary dial 7.
In addition, the wipe interval is varied
automatically depending on road
speed.
Rain sensor:
When the rain sensor is activated, the
windshield wiper is controlled automati-
cally, depending on the degree of wet-
ness of the windshield (in both snow
and rain). You do not have to be con-
cerned with switching the windshield
wiper on or off or adjusting the wipe
interval between intermittent and full
wipe. Instead, you can concentrate fully
on the traffic conditions. This is espe-
cially important under adverse weather
conditions.
The rain sensor is positioned on the
windshield, directly in front of the inte-
rior rearview mirror.
windshield wiper is controlled automati-
cally, depending on the degree of wet-
ness of the windshield (in both snow
and rain). You do not have to be con-
cerned with switching the windshield
wiper on or off or adjusting the wipe
interval between intermittent and full
wipe. Instead, you can concentrate fully
on the traffic conditions. This is espe-
cially important under adverse weather
conditions.
The rain sensor is positioned on the
windshield, directly in front of the inte-
rior rearview mirror.
To activate the rain sensor:
Move the lever to position 1 with the
ignition key in position 1 or higher. The
wipers travel once across the wind-
shield, regardless of the weather condi-
tions.
Move the lever to position 1 with the
ignition key in position 1 or higher. The
wipers travel once across the wind-
shield, regardless of the weather condi-
tions.
You can leave the lever permanently in
position 1. It is then only necessary to
activate the rain sensor from ignition
key position 1 and up. To do this,
position 1. It is then only necessary to
activate the rain sensor from ignition
key position 1 and up. To do this,
>
turn rotary dial 7 briefly or
>
clean the windshield 5 or use the
special wash program 6.
special wash program 6.
To adjust the sensitivity of the rain
sensor:
Turn rotary dial 7.
sensor:
Turn rotary dial 7.
Turn the rain sensor off in auto-
matic car washes. If you do not,
matic car washes. If you do not,
damage may occur if the wipers switch
on unintentionally.
on unintentionally.
<
2 Normal wiper speed
The system switches automatically to
intermittent operation when the vehicle
is not moving (not on vehicles with the
rain sensor
intermittent operation when the vehicle
is not moving (not on vehicles with the
rain sensor
*
).
3 Fast wiper speed
The wipers operate at normal speed
when the vehicle is not moving (not on
vehicles with the rain sensor
when the vehicle is not moving (not on
vehicles with the rain sensor
*
).
5 Clean the windshield
The system sprays washer fluid against
the windshield and activates the wipers
for a brief period.
the windshield and activates the wipers
for a brief period.
If you pull the lever only briefly, the sys-
tem sprays washer fluid onto the wind-
shield without activating the wipers.
tem sprays washer fluid onto the wind-
shield without activating the wipers.
6 Special wash program
*
As at 5; there are also several additional
wash cycles, and the headlamps are
cleaned
wash cycles, and the headlamps are
cleaned
*
.
This program is recommended after you
have driven on extremely dirty roads.
have driven on extremely dirty roads.
Headlamp washers
*
>
With the Special wash program 6
>
With every fifth actuation of Clean
windshield 5 when the vehicle's
lighting is switched on.
windshield 5 when the vehicle's
lighting is switched on.
Do not use the washers if there is
any danger that the fluid will
any danger that the fluid will
freeze on the windshield. If you do so,
your vision could be obscured. For this
reason, use an antifreeze agent. Refer
to page
your vision could be obscured. For this
reason, use an antifreeze agent. Refer
to page
Do not use the washers when the reser-
voir is empty. This could cause damage
to the washer pump.
voir is empty. This could cause damage
to the washer pump.
<
Windshield washer jets
The windshield washer jets are warmed
automatically when the ignition key is in
position 2.
automatically when the ignition key is in
position 2.
Online Edition for Part No. 01 41 0 155 303 - © 12/99 BMW AG