BMW z4 2005 Manual Do Utilizador

 91

The onboard tool kit is stored in a tool pouch. It 
is located in the luggage compartment beneath 
the floor panel.

1.

Swich off the ignition

2.

Fold the wiper arm completely out from the 
windshield

3.

Place the wiper blade in a position at right 
angles to the wiper arm

4.

Press the locking spring

5.

Fold the wiper blade down and unhook it 
toward the windshield

6.

Pull the wiper blade past the wiper arm 
toward the top

7.

Insert a new wiper blade and apply pressure 
until you hear it engage.

The lamps and bulbs make essential contribu-
tions to the safety of your vehicle. Therefore, 
comply fully with the following instructions dur-
ing bulb replacement. If you are not familiar with 
the procedures, BMW recommends that you 
have your BMW center carry out the work.

Do not touch the glass portion of a new 
bulb with your bare hands since even 

small amounts of impurities burn in to the sur-
face and reduce the service life of the bulb. Use 
a clean cloth, paper napkin or a similar material, 
or hold the bulb by its metallic base.

<

A replacement bulb set is available from your 
BMW center.

Before working on the electrical system, 
switch off the electrical accessory you are 

working on or disconnect the cable from the 
negative terminal of the battery. Failure to 
observe this precaution could result in short cir-
cuits.
To prevent injuries and damage, always comply 
with any instructions provided by the bulb man-
ufacturer.

<

To gain access to the headlamp covers, turn the 
front wheels in the required direction.

Online Edition for Part-No. 01 41 0 158 704 - © 10/04 BMW AG