BMW z4 roadster 2.5i-2003 Manual Do Utilizador

Giving and receiving assistance

Start the engine on the support vehicle
and allow it to run

Open the cover of the BMW jump-start
support terminal by pulling on the tab;
see arrow.

Connect jumper cable

Always adhere to this sequence when
connecting jumper cables, even when

jump-starting other vehicles. Failure to
observe this procedure can lead to sparks
and pose a danger of personal injury.

With the + jumper cable, connect the
positive terminal of the drained battery
and the positive terminal of the support
battery

With the – jumper cable, connect the
negative terminals of both vehicles.
Your BMW is equipped with a special
nut for this purpose, refer to Engine
compartment on page

To do so:

Attach one cable clamp to the nega-

tive battery terminal or to a suitable
ground on the engine or body work of
the support vehicle

Attach the second cable clamp to

the negative battery terminal or to a
suitable ground on the engine or body
work of the vehicle to be jump-started.

Jump-starting the vehicle

Let the engine of the support vehicle
run for several minutes at a slightly ele-
vated engine idle speed

Start the engine of the other vehicle as
usual

If the first start attempt is not suc-

cessful, wait a few minutes before
another attempt in order to allow the
discharged battery to recharge.

Let the engines run for several minutes

Then disconnect the jumper cables in
reverse sequence.

Depending on the cause of the fault,
have the battery checked and

recharged at a BMW center.

Towing and tow-starting the
vehicle

Towing eyelet

The screw-in towing eyelet is stored in the
onboard tool kit; be sure that it remains in
the vehicle at all times. This eyelet is
designed for installation in the tow sockets
located at the front and rear of the vehicle,
and is intended for towing on paved road
surfaces only.

Access to towing socket

Front:
Press out the cover panel with a screw-
driver inserted in the recess at the top.