Yamaha 02R Manual Do Utilizador

Mixing and Monitoring

You can monitor input channels in isolation by pressing the [SOLO] button. 
The LEDs in the centre of the selected channel [ON] buttons are 
extinguished. You select the channel(s) you want to solo by pressing the 
corresponding [ON] button. When you press the [SOLO] button again, the 
originally selected LEDs are illuminated again.

The talkback system allows you to talk to musicians in the studio without 
leaving the Digital Recording Console 02R. Press the [T/B] button and start 
talking. The [SLATE] button sends the talkback signal to the main buses as 
well as the stereo bus, for example, allowing you to record a memo before 
recording a take.

You can also record 100 Hz, 1 kHz, and 10 kHz sine waves and white noise 
tones by using the oscillator function. See “Oscillator” on page 165 of the 
User’s Guide for details.

This control is used to adjust the volume output through the control room 
monitor outputs.

This control adjusts the volume of the talkback signal. The talkback signal 
is picked up by the built-in microphone right below the control.

This control is used to adjust the overall volume output through the studio 
monitor outputs.

If you are using a headphone amplifier to provide studio monitoring, you 
may need a unit that allows individual adjustment of each set of 
headphones.

This control is used to adjust the volume of a set of stereo headphones 
plugged into the connector just above the control.