Yamaha 02R Manual Do Utilizador

Getting Started

This section explains how to power the Digital Recording Console 02R on 
and off.

It is always important to observe the correct order for powering up 
equipment in a studio. Always start with the multitrack and mastering 
recorders and the signal processors, then the 02R, and finally the 
monitoring amplifiers and other downstream gear.

The 02R start-up screen appears for a few seconds, the faders initialize 
themselves, then the screen that was used when the 02R was last powered 
off appears.

It is always important to observe the correct order for powering up 
equipment in a studio. Always start with the monitoring amplifiers and 
other downstream gear, then the 02R, and finally the multitrack and 
mastering recorders and the signal processors.

All mix settings, mix scenes, and other data are stored when the 02R is 
powered off.

Before you use the 02R with a modular digital multitrack recorder or DAT 
master recorder, be sure to correctly set the synchronization. The 02R must 
be slaved to an external wordclock in order to process the input digital 
signals without drop-out or distortion. Refer to the section “Word Clock 
Select” on page 154 of the User’s Guide.

Look in the chapter “Installing Options” on page 171 of the User’s Guide. 
There is a section for each of the optional digital I/O cards that the 02R 
supports. Refer to the appropriate section for the card installed in your 
unit.