Yamaha 1100 Manual Do Utilizador

• Copying cannot be done 

between a 2DD disk and 
2HD disk. When copying, 
make sure both disk are 
the same type.

• Depending on the amount 

of data contained in the 
original source disk, you 
may have to swap the two 
disks several times until all 
of the data is properly 
copied.

• Make sure to read the 

section “Using the Floppy 
Disk Drive (FDD) and 
Floppy Disks” on page 7.

Turns the Song Auto Open function on or off. 
When this is set to “ON,” the PSR-2100/1100 
automatically calls up the first disk song when 
a disk is inserted.

This function copies all the data 
from one disk to another, letting you 
back up all your important data 
before editing. For instructions, see 
“Copying from Disk to Disk” below.

This function formats a 
floppy disk (see below).

Source

disk

Copy

Copy

Destination

disk

Copying from Disk to Disk
As shown below, first copy the data of the original (source) disk to the PSR-2100/1100, 
then copy the data to the backup (destination) disk.

Press the [F] button. A message 
appears, prompting you to insert 
the source disk.

Insert the disk containing the 
original data into the drive and 
press “OK.”
A “Now copying” message 
appears, and the PSR-2100/
1100 begins copying data to 
internal memory. To abort the 
operation, press “CANCEL.”

At the “Please insert a destination 
disk and press the OK button ” 
prompt, eject the source disk and 
replace it with a blank, formatted 
disk, then press “OK.” To abort the 
operation, press “CANCEL.”

When the operation is finished 
(or when prompted), eject the 
destination disk.

Commercially available 
music data is subject to 
protection by copyright 
laws. Copying commer-
cially available data is 
strictly prohibited, 
except for your own per-
sonal use. Some music 
software is purposely 
copy-protected and 
cannot be copied.

Formatting a Disk
When using an unformatted disk for the first time, make sure to properly 
format it on the PSR-2100/1100. This includes blank disks as well as disks 
already initialized in a different format. Formatting erases all data on the 
disk.

Insert the disk with shutter facing away from you and the label side up. To 
start the Format operation, press the [H] (DISK FORMAT) button, in the 
DISK page above.

The Format operation initializes a disk 
with a specific file system, allowing the 
corresponding device (in this case, the 
PSR-2100/1100) to access it properly.
Since there are several types of for-
mats and disks available, you should 
know which ones to use with the PSR-
2100/1100. 2DD disks are formatted to 
a capacity of 720 KB, and 2HD disks 
are formatted to a capacity of 1.44 MB.

Disk Lamp
When the power is turned 
on, the disk lamp (at the 
bottom left of the drive) 
lights to indicate the drive 
can be used.