Yamaha 9000 pro Manual Do Utilizador

Installing Optional Hardware

184

Reference

Optional Hard Disk Installation

The hard disk used must be a 2.5-inch IDE-compatible; however, not all such drives may be installable.

For information on the hard disk recommendations, ask your nearest Yamaha representative or an
authorized distributor listed at the end of this owner’s manual. Install a hard disk at your own risk.
Yamaha will not be held responsible for any damage or injury resulting from improper installation
or the use of a hard disk other than one of the types recommended by Yamaha.

1-4

Use the same operation as in "Optional Plug-in Board Installation"
(page 181).

Remove the four screws from the Plug-in board/Hard disk
cover.

Turn over the Plug-in board/Hard disk cover.

If a Plug-in Board (or boards) is installed, make sure to disconnect the Plug-in Board con-
nector(s) before continuing.

Hold the hard disk unit in place with your hand as shown below. Make
sure that the socket end of the unit faces toward you as shown.

CAUTION

• When inserting hard disk unit and connecting cables, make sure that you check that they are inserted and

connected properly. Improperly inserted hard disk unit and cables may cause faulty contacts and an electri-
cal short circuit which may cause damage or result in a malfunction.

• After mounting the hard disk unit, be sure to tighten the screws as directed so it is completely stable and

does not move in any way.

• Hard disk drives of a maximum 8 GB capacity can be formatted; however, the maximum partition size is 2 GB. For

example, an 8 GB hard disk drive would have to be formatted into four separate 2 GB partitions.

• Hard disk drives of a capacity greater than 8 GB can be installed; however, the 9000Pro is capable of formatting only

up to a maximum 8 GB on the drive.

• Hard disk drives wider than 12.7 mm cannot be installed to the 9000Pro.

WARNING

• In order not to drop any screws inside the 9000Pro, keep the Plug-in Board and cover away from the 9000Pro

in the following steps #5 - #8.
If the Plug-in Board has been installed, pull out the cable connector from the Plug-in Board connector.

Silver screws

Plug-in board stand

This is the location for
the Hard disk unit.

Plug-in board/Hard disk cover

Hard disk unit:
top side face up

Turn over

Align the holes in the cover with the
holes on the hard disk. The actual
placement of the holes may differ
depending on the particular hard disk.

182