Yamaha aw16g Manual Do Utilizador

169

By connecting an MD recorder to the AW16G’s DIGITAL 
STEREO IN or DIGITAL STEREO OUT jack, you can mix-
down to the MD recorder while keeping the signal in the 
digital domain, or record an audio signal from the MD 
recorder into the AW16G.

Here’s how you can connect an MD recorder to the 
AW16G’s DIGITAL STEREO OUT jack and mix down. 
The DIGITAL STEREO OUT jack always outputs the same 
signal as is recorded on the stereo track. This means that 
the procedure is essentially the same as for normal mix-
down.

Lower the [STEREO] fader to the –

∞

 position.

As shown in the diagram below, use an opti-
cal cable to connect the AW16G to your MD 
recorder.

Use the Quick Navigation section [RECORD] 
key to access the MIXDOWN page of the 
RECORD screen, and select the channels that 
you want to send to the stereo bus.

Raise the [STEREO] fader to the 0 dB position, 
and while you play back the song, adjust the 
level, pan, EQ, and dynamics for each track 
channel.

If desired, you can also use the mastering library.

When you have finished adjusting the sound 
and the levels, put your MD recorder in 
record mode, then play the AW16G from the 
beginning and perform the mixdown.

You do not need to turn on the REC button in the 
MIXDOWN page at this time.

When you have finished the mixdown, stop 
the AW16G and your MD recorder.

● Signal flow when mixing down to an MD recorder

DIGITAL

STEREO IN

DIGITAL
STEREO OUT

DIGITAL

STEREO OUT

DIGITAL
STEREO IN

MONITOR
OUT

Mixer section

Stereo bus

Stereo output 

channel

Recorder section

Track 

channels

Track 1
Track 2
Track 3
Track 4
Track 5
Track 6
Track 7
Track 8