Yamaha CD8-mLAN Manual Do Utilizador
10
English
DIP switch settings
The circuit board of the CD8-mLAN has several DIP switches. Two of these (switches 1 and 3)
must be set appropriately for your situation. Refer to the following explanation and make the
appropriate settings.
must be set appropriately for your situation. Refer to the following explanation and make the
appropriate settings.
DIP switch 1: SERIAL I/O
Set this “ON” if you wish to use SERIAL I/O for MIDI message input and output. Set this “OFF” if
you wish to use mLAN Patchbay on your computer (Windows). When the CD8-mLAN is shipped
from the factory, this is set to “OFF.”
you wish to use mLAN Patchbay on your computer (Windows). When the CD8-mLAN is shipped
from the factory, this is set to “OFF.”
DIP switch 3: MODEL
Information for the model (module) name of device in which the CD8-mLAN is installed is trans-
mitted to other mLAN devices or to mLAN Patchbay according to this setting. Set this “ON” if
installing the CD8-mLAN in an 02R. Set this “OFF” if installing the CD8-mLAN in an 03D. When
the CD8-mLAN is shipped from the factory, this is set to “ON.”
mitted to other mLAN devices or to mLAN Patchbay according to this setting. Set this “ON” if
installing the CD8-mLAN in an 02R. Set this “OFF” if installing the CD8-mLAN in an 03D. When
the CD8-mLAN is shipped from the factory, this is set to “ON.”
You do not need to make settings for DIP switches 2 and 4–8.
The factory settings are as follows.
No.
1
2
3
4
5
6
7
8
OFF
ON
ON
OFF
OFF
OFF
OFF
OFF
ON
1 2 3
SW3
4 5 6 7 8
03D
SWITCH
POSITION
No.
Function
ON
OFF
1
SERIAL I/O
MIDI
PC
3
MODEL
02R
NOTE
NOTE
CD8-(E).book Page 10 Friday, October 6, 2000 3:22 PM