Yamaha CRW2200IX Manual Do Utilizador
Setup Procedures
13
Before connecting the CRW2200IX drive and the computer as described below,
make sure that you have installed appropriate CD writing software (
make sure that you have installed appropriate CD writing software (
P. 5). If you
use Windows and if the CD writing software is newly installed, first disconnect all
IEEE1394 devices from your computer. After properly installing the software, you
can connect the CRW2200IX drive. For information about how to install the
software, refer to the documentation that came with it.
IEEE1394 devices from your computer. After properly installing the software, you
can connect the CRW2200IX drive. For information about how to install the
software, refer to the documentation that came with it.
If your computer has no built-in IEEE1394 port, you will first need to install an
IEEE1394 interface card (purchased separately). For information about how to install
the card, refer to the documentation that came with it.
IEEE1394 interface card (purchased separately). For information about how to install
the card, refer to the documentation that came with it.
1
1
1
1 Turn on the computer.
2
2
2
2 Make sure that the power switch on the rear panel of the CRW2200IX
drive is set to STANDBY.
3
3
3
3 Connect the included AC adapter to the DC-IN connector of the drive
with the arrow on the adapter plug facing left, as shown below.
Install the CD Writing Software
Set Up the CRW2200IX Drive
Arrow
DC-IN
connector
connector
Screw
00GB-.book Page 13 Wednesday, June 27, 2001 7:24 PM