Yamaha CRW4261t-NB Manual Do Utilizador

Chapter 2 - Installing the Yamaha CRW4261t Drive

Setting the CRW4261t as the MASTER

As shown in the diagram at the right, insert the

jumper pin into the right edge of the jumper

switch.

Note:

If only the CRW4261t will be connected to the

IDE interface connector, connect the

CRW4261t to the end of the connector.

Setting the CRW4261t as the SLAVE

As shown in the diagram at the right, insert the

jumper pin into the middle of the jumper

switch.

CSEL (Cable SELect)

If you use the CSEL setting, the MASTER/SLAVE setting will be

made automatically depending on the hardware configuration.

For details refer to the manual of your computer.

CSEL
SLAVE
MASTER