Yamaha CVP-600 Manual Do Utilizador

122

CVP-98/96/600

Press the 

TRACK EDIT button in the RECORD [EDIT] display to

call up the TRACK EDIT display.  There are three pages in the TRACK
EDIT display: TRACK EDIT [MIX], TRACK EDIT [DELETE], and
TRACK EDIT [QUANTIZE].

Track Copy
• Only tracks containing data will appear

and can be selected for 

TRACK A

 and

TRACK B

.  In addition, “- - -” (no track)

can also be selected for 

TRACK B

.  In

this case, the data of 

TRACK A

 will

simply be copied to 

TRACK C

.

• For the Track Mix function, the se-

lected track voice and volume data,
etc. (i.e., all data except note data) of

TRACK A

 will be effective for the track

after the mix operation.

■

The Track Mix function combines the data from two specified tracks

and copies the  result to a third specified track.

Song Recording

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○

Z

Press the 

TRACK A and TRACK B buttons to highlight the param-

eters, and use the data dial or [–/+] buttons to select the two track num-
bers to be mixed.  The voices which are used for the selected tracks are
indicated at the side of A:/B:, located at the left of the LCD display.

X

Use the 

TRACK C parameter to specify the track to which you want

to record the mixed data.  You can also specify the track for the mixed
data by highlighting the appropriate section using the 

TRACK C button,

then using the data dial or [–/+] buttons.

Any previous data in the destination track will be erased.

C

Press the 

MIX button to begin execution of the Track Mix operation.

An “Are you sure?” confirmation prompt will appear.  Press 

YES to ex-

ecute the Track Mix operation or press 

NO to cancel.

When this is completed, the 

MIX button will change to UNDO, al-

lowing you to undo the Track Mix operation and restore the previous
data (before mixing).

Press the [REC] button (the lamp goes out) to exit the Track Mix

function.

You can also exit the Track Mix function by pressing the [EXIT]

button.

• The previous data of the mixed track

will remain even after executing Track
Mix.  If the old data is not needed, you
should delete it.  (See “Track Delete”
below.)

• A bar graph indicating the progress of

the Track Mix operation will appear
while the data is being processed.

• You can check if the results are as you

expected or not, by starting and stop-
ping playback with the [PLAY/STOP]
button before performing the 

UNDO

operation.

• The Undo function cannot be used if

you’ve selected another track or exited
from this mode.

• The Undo feature cannot be used for

data recorded to internal RAM (see
page 127).