Yamaha dvd-s30 Manual Do Utilizador

If there is any problem with your system, check the following items. If you cannot solve your problem with the following 
remedies or if your problem is not listed below, turn off and unplug the unit, then consult the nearest authorized 
YAMAHA dealer or service center.

■ General

■ Remote control

The power cable may be connected 
improperly.

Make sure the power cable is plugged into the 
outlet firmly.

This unit may receive a strong electrical 
shock such as from a lightening bolt or 
excessive static electricity.

Set this unit to the Standby mode, then 
disconnect the power cable. Wait for about 
30 seconds, then connect the power cable 
and turn on this unit.

The cables may be connected improperly.

Make sure all cables are connected properly. 
(

The disc loaded into this unit may be not 
compatible.

Make sure you use a disc supported by this 
unit. (

A DTS source is played back using an analog 
output jack.

Use a digital connection to play back a DTS 
source.

A DTS source is played back while “PCM 
ONLY” is selected for “DIGITAL 
OUTPUT” in the Setup menu.

Select “ALL” for “DIGITAL OUTPUT” in 
the Setup menu. (

)

The cables may be connected improperly.

Make sure all cables are connected properly. 
(

The Sleep feature (page 22) might be set.

Turn on this unit and play the source again.

The remote control may be operated 
outside the remote control operation 
range.

For information on the remote control 
operation range, refer to “Using the Remote 
Control” (

The remote control sensor on this unit 
may be exposed to direct sunlight or 
lighting (inverted fluorescent lamps).

Change the lighting or this unit’s orientation.

The batteries may be worn out.

Replace the batteries with new ones. (

)