Yamaha EMX66M Manual Do Utilizador

 

EMX66M Quick Guide

 

The following steps (1–5) explain the basic con-
nection and operation of the EMX66M.
Also, please read “Front and Rear Panel” and 
“Basic Operation” following this Quick Guide 
section to learn more about using the EMX66M.

 

Using speaker cables, connect each speaker to the   
A 1 or 2 jack and to the B 1 or 2 jack in the 
SPEAKERS jack section on the rear panel of the 
EMX66M.

 

• You may connect to either of the two jacks on the 

speakers.

• Be sure to use a cable designed for speaker connection.

 

Never connect the speakers in the manner shown 
below. Otherwise, the EMX66M’s built-in power 
amplifier will be damaged.

 

Set the power amp select switch (located on the 
right corner on the panel) to MAIN-MAIN.

 

• This Quick Guide assumes that two main speakers 

are connected. Refer to pages 16–17 for other con-
nections and power amp select switch settings.

 

Make sure that the power is turned off to the 
EMX66M.
Connect a microphone to the Low-Z jack of 
channel 1–4.

 

Turn on the PHANTOM switch (located in the upper 
right corner on the panel).

• Do not connect or disconnect a condenser micro-

phone while the power to the unit is on and the 
PHANTOM switch has been turned on.

EMX66M

EMX66M

EMX66M

EMX66M

EMX66M

Power amp select switch

EMX66M

Microphone

EMX66M

PHANTOM switch