Yamaha GO46 Manual Do Utilizador

E

[MASTER] knob
Controls the levels of the analog outputs (OUTPUT 1/2 or OUTPUT 3/4). The output pair to be
controlled can be selected via the Push function (OUTPUT 1/2 or OUTPUT 3/4 or both jacks).
The output pair currently being controlled can be monitored by the MAIN/MONITOR LED. In
addition, pressing and holding the knob for 2 seconds or more will mute the channels cur-
rently being controlled. This can be used to switch back and forth between two monitor
speaker sets for a direct comparison. This function is also available via the GO46 Control
Panel. (See page 20.)

F

MAIN and MONITOR LED
Indicates the output pair currently being controlled by the master or muted. The MAIN LED
corresponds to OUTPUT 1/2 jacks, MONITOR LED to OUTPUT 3/4. The following overview
describes the operation and displays:

G

HEADPHONE LEVEL knob
Adjusts the output level of the PHONES jack.

H

PHONES jack
Output for a 1/4" stereo headphone jack. The signal from OUTPUT 3/4 on the rear panel is
always available at the PHONES jack. The actual signal available there depends on the routing,
which you can set up to suit your needs in the GO46 Control Panel. (See page 20.)

On

Off

OUTPUT 1/2 level

OUTPUT 1/2 muted

Off

On

OUTPUT 3/4 level

OUTPUT 3/4 muted

On

On

OUTPUT 1/2, 3/4 level

OUTPUT 1/2, 3/4 muted

Flashing

Off

OUTPUT 1/2 level

(OUTPUT 1/2 muted)

OUTPUT 1/2 unmuted

Flashing

On

OUTPUT 3/4 level 

(OUTPUT 1/2 remains muted)

OUTPUT 1/2, 3/4 muted

Off

Flashing

OUTPUT 3/4 level

(OUTPUT 3/4 muted)

OUTPUT 3/4 unmuted

On

Flashing

OUTPUT 1/2 level 

(OUTPUT 3/4 remains muted)

OUTPUT 1/2, 3/4 muted

Flashing

Flashing

OUTPUT 1/2, 3/4 level

(OUTPUT 1/2, 3/4 muted)

OUTPUT 1/2, 3/4 unmuted