Yamaha f200d Manual Do Utilizador
Maintenance
52
CAUTION:
ECM00490
This procedure must be performed while
the outboard motor is in the water. A flush-
ing attachment or test tank can be used.
the outboard motor is in the water. A flush-
ing attachment or test tank can be used.
A diagnostic tachometer should be used for
this procedure. Results may vary depending
on whether testing is conducted with the
flushing attachment, in a test tank, or with the
outboard motor in the water.
1.
this procedure. Results may vary depending
on whether testing is conducted with the
flushing attachment, in a test tank, or with the
outboard motor in the water.
1.
Start the engine and allow it to warm up
fully in neutral until it is running smoothly.
2-hp model: Warm the engine with the
throttle in the start position or less. If the
outboard is mounted on a boat, be sure
the boat is tightly moored.
fully in neutral until it is running smoothly.
2-hp model: Warm the engine with the
throttle in the start position or less. If the
outboard is mounted on a boat, be sure
the boat is tightly moored.
NOTE:
Correct idling speed inspection is only possi-
ble if the engine is fully warmed up. If not
warmed up fully, the idle speed will measure
higher than normal. If you have difficulty veri-
fying the idle speed, or the idle speed requires
adjustment, consult a Yamaha dealer or other
qualified mechanic.
ble if the engine is fully warmed up. If not
warmed up fully, the idle speed will measure
higher than normal. If you have difficulty veri-
fying the idle speed, or the idle speed requires
adjustment, consult a Yamaha dealer or other
qualified mechanic.
2.
EMU29083
Changing engine oil
WARNING
EWM00760
●
Avoid draining the engine oil immediate-
ly after stopping the engine. The oil is
hot and should be handled with care to
avoid burns.
ly after stopping the engine. The oil is
hot and should be handled with care to
avoid burns.
●
Be sure the outboard motor is securely
fastened to the transom or a stable
stand.
fastened to the transom or a stable
stand.
CAUTION:
ECM01240
Change the engine oil after the first 10
hours of operation, and every 100 hours or
at 6-month intervals thereafter. Otherwise
the engine will wear quickly.
hours of operation, and every 100 hours or
at 6-month intervals thereafter. Otherwise
the engine will wear quickly.
NOTE:
Change the engine oil when the oil is still
warm.
warm.
The engine oil can be extracted with an oil
changer (recommended), or drained by re-
moving the oil drain screw.
Extracting the oil with an oil changer (normal
oil change)
1.
changer (recommended), or drained by re-
moving the oil drain screw.
Extracting the oil with an oil changer (normal
oil change)
1.
Put the outboard motor in an upright po-
sition (not tilted).
sition (not tilted).
2.
Pull out the dipstick and use the oil
changer to extract the oil.
changer to extract the oil.
U69J14E0.book Page 52 Friday, March 12, 2004 10:20 AM