Yamaha mfc10 Manual Do Utilizador

MIX Mode

In the MIX mode, both Program Change data and Function data can be accessed at the
same time without having to change between modes with the [FUNCTION] switch. This
mode provides quick transmission of Program Change data and Function data.

In this mode, up to 25 different Program memories (independent of the NORMAL mode)
can be saved and accessed from the lower level of foot switches [1]-[5], and up to 5
different Function memories can be saved and accessed from the upper level of foot
switches [6]-[0]. Each of those memories can be selected and transmitted with the [1]-[0]
and [x10] foot switches.

1

Set the [FUNCTION NORMAL-MIX] switch on the
rear panel to the [MIX] position.

NORMAL — MIX

FUNCTION

2

Press [FUNCTION] and turn off the  FUNCTION
lamp.

If [FUNCTION] is pressed while in the MIX mode
(the FUNCTION lamp lights), the MIX mode’s
FUNCTION memory (see page 21) will be enabled. All
foot switches can access the MFC10’s 100 FUNCTION
memories.

The 10's digit setting is valid when the MFC10 is
returned to the MIX mode. Press [FUNCTION] once
again, the FUNCTION lamp turns off, and the MFC10
is returned to MIX mode.

* The contents of each Function Memory number is same data between NORMAL mode and MIX mode. Program

Change Memory exists independently in each mode.

* Default setting for Program Change Memory in the MIX mode.

11[C0, 00], 12[C0, 01], 13[C0, 02], 14[C0, 03], 15[C0, 04], 21[C0, 05], 22[C0, 06], ...