Yamaha MW12 Manual Do Utilizador

MW12 Owner’s Manual

7

This quick setup and operation guide covers everything from installing the Cubase LE software to using Cubase LE 

for recording and mixdown. While going through this section you might find it useful to also refer to the “Front and 

Rear Panels” section on page 15, as well as the pdf manual supplied with the Cubase LE software.

The serial number is printed on the sheet located inside the CD-ROM envelope.

n

• Please install Cubase LE while connected to the internet.
• Please enter all required items during installation.
• For Macintosh computers double-click the “Cubase LE.pkg” icon.

Connect the MW12 mixer to your computer using the 
supplied USB cable.

When connecting or disconnecting the USB cable 
be sure to turn the 2TR IN/USB control all the way 
down.

n

Disconnect the USB cable before you use the 
computer without the MW12.

For details on making connections refer to the “Rear 
Input/Output” section on page 19, and the “Setting Up” 
section on page 21.

Be sure to observe the following points when connecting to the 
computer’s USB interface. Failure to observe these rules can 
result in computer freezes/hang-ups and possibly data loss or 
corruption.
If the computer or MW12 does stop operating properly, turn 
the power off and then on again, and restart the computer.

• Be sure to wake the computer from 

sleep/suspended/standby mode before making a 
connection to the computer’s USB connector.

• Connect the MW12 to the computer before turning the 

MW12 power on.

• Always quit all applications running on the computer 

before turning the MW12 power on or off, or connecting 
or disconnecting the USB cable.

• Wait at least 6 seconds between turning the MW12 on or 

off, and between connecting or disconnecting the USB 
cable.

Be sure turn the MW12 
PHANTOM switch on when 
using phantom-powered 
condenser microphones.

Although electric guitars and 
basses can be connected 
directly to the mixer’s inputs, 
the sound is likely to be thin 
and possibly noisy. For best 
results with these types of 
instruments use a DI box 
(direct box), guitar/bass 
preamplifier, or amp simulator 
between the instrument and 
the mixer.

USB Cable