Yamaha MT8XII Manual Do Utilizador
28
Punch In/Out Recording
MT8XII—Owner’s Manual
Performing Auto Punch for Real
This section continues on from the Rehearsing Auto Punch section.
1. Press the [REC/PAUSE] button.
The REC/PAUSE indicator flashes. This is Auto Punch Record Standby mode.
2. Press the [PLAY] button (or footswitch) to start the Auto Punch In/Out
sequence.
Playback starts and the PLAY indicator lights up. The REC/PAUSE indicator continues to flash,
indicating Play Record Wait mode.
indicating Play Record Wait mode.
At the specified punch-in point, punch in occurs (i.e., recording starts). The REC/PAUSE indi-
cator stops flashing and lights up continuously. The IN indicator appears on the display.
cator stops flashing and lights up continuously. The IN indicator appears on the display.
If you’re monitoring the track via CUE (i.e., [FLIP] switch in the up position), you’ll hear the
existing sounds playback until the punch-in point. After which you’ll hear the new sound that’s
being recorded.
existing sounds playback until the punch-in point. After which you’ll hear the new sound that’s
being recorded.
At the specified punch-out point, punch out occurs (i.e., recording stops). The REC/PAUSE
indicator goes out and the OUT indicator appears on the display.
indicator goes out and the OUT indicator appears on the display.
Playback continues up to the post-roll point. Then the tape rewinds back to the pre-roll point.
Press the [PLAY] button to audition the punch in/out.
Press the [PLAY] button to audition the punch in/out.
The following illustration shows the Auto Punch Record sequence.
Pre-roll
point
8
7
6
5
4
7
6
5
4
3
2
1
1
Play Record
Wait
Play
REC
SELECT
Record
Post-roll
point
Punch-in
point
Punch-out
point
PLAY
REC/PAUSE
or