Yamaha NS-AP1400 Manual Do Utilizador
SETTING UP THE SPEAKERS
SPEAKER PLACEMENT
SPECIFICATIONS
LISTENING AREA
Center Channel Speaker
6 ∼ 10 feet
Left Surround Speaker
Left Surround Speaker
Left Main Speaker
Min.
20mm
6mm
Min.
20mm
6mm
Tapping screw
(Available at the
hardwarestore)
(Available at the
hardwarestore)
Min.
20mm
6mm
up to approx
2 feet more
up to approx
2 feet more
Right Main Speaker
Main and rear speakers can be positioned
horizontally or vertically.
Please install rubber feet included to prevent
slipping movement.
Please note: Logo can rotate.
horizontally or vertically.
Please install rubber feet included to prevent
slipping movement.
Please note: Logo can rotate.
This speaker is designed to be used as a main, center, surround or effects speaker
- Main speaker placement should be separated by distance of 6-10ft. If they are placed
too close together, there will be a reduction in the stereo effect.
Conversely. If placed too far apart, the so called
Conversely. If placed too far apart, the so called
"middle-omission" effect will occur and
the vocal center fill will be lost. Height of the speaker should be at least at ear level.
- Center channel speakers should be placed centered above or below the TV.
- Surround speakers should ideally be placed behind the listening area. At least as far
- Surround speakers should ideally be placed behind the listening area. At least as far
apart as the main speakers and up to 2 additional feet apart per side. The height of the
speaker should be at a minimum of ear level or preferably somewhat higher.
speaker should be at a minimum of ear level or preferably somewhat higher.
Model
NS-AP1400
Center Speaker
NS-AP1400C
Type
2-way Acoustic Suspension
Speaker: Woofer
Dual 2
3/4
" Pulp cone and Rubber surround
Speaker: Tweeter
1/2" Balanced dome
Frequency Range
90Hz ~ 50kHz (-10dB)
Impedance
6 ohms
Nominal Input
30w
Maximum Input
100w
Sensitivity (dB/2.83v. 1m)
80dB
Crossover Frequency
4,500Hz
Dimension (H
×W×D)
3
5/8
"
×9
7/8
"
×4
3/8
" (92
×250×111mm)
Weight
2,51lbs(1.14kg)
Finish
Silver and Black
Magnetic Shielding
Yes
Main and rear
NS-AP1400S
Type
2-way Acoustic Suspension
Speaker: Woofer
2
3/4
" Pulp core and Rubber surround
Speaker: Tweeter
1/2
" Balanced dome
Frequency Range
90Hz ~ 50kHz (-10dB)
Impedance
6 ohms
Nominal Input
30w
Maximum Input
100w
Sensitivity (dB/2.83v.ln)
80dB
Crossover Frequency
4,000Hz
Dimension (H
×W×D)
6
5/8
"
×3
5/8
"
×4
1/8
"(168
×92×106mm)
Weight
1.76 lbs (0.80kg)
Finish
Silver and Black
Magnetic Shielding
Yes
Accessories
100" Bulk Speaker Wire
3/8
"
×
3/32
" Rubber foot 16pcs
1
17/32
"
×2" Velcro
TM
2pcs
*Specifications subject to change without notice due to product improvements.
WARNING
●
Each speaker weight 1.76 lbs (0.80kg). Do not mount them on thin plywood or soft
surface material. If mounted, the screw may come out of the flimsy surface and the
speakers may fall. This damages the speakers or causes personal injury.
surface material. If mounted, the screw may come out of the flimsy surface and the
speakers may fall. This damages the speakers or causes personal injury.
●
Do not install the speakers to a wall with nails, adhesives, or any other unstable
hardware.
hardware.
●
To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall.
●
Secure installation is the purchaser’s responsibility.
Please place rubber feet as shown in the diagram
prior to mounting the speakers on the wall.
prior to mounting the speakers on the wall.
Fasten screws into a film wall or wall
support as shown in the figure, and hang
the holes of the mounting bracket on the
protruding screws.
the holes of the mounting bracket on the
protruding screws.
★Make sure that the screws are securely
caught by the narrow sections of the “key
hole” opening. Main and rear speakers can
be mounted horizontally or vertically.
hole” opening. Main and rear speakers can
be mounted horizontally or vertically.
Place the center speaker on top of the TV, on the floor under
the TV or inside the TV rack so that it is stable.
When placing the speaker on top of the TV, put the provided
Velcro
the TV or inside the TV rack so that it is stable.
When placing the speaker on top of the TV, put the provided
Velcro
TM
strips at two points on both the bottom of the speaker
and on top of the TV to prevent the speaker from falling.
1400-page (4-5)
286×215
Vertical position
Horizontal position
Notes
●
Do not place the speaker on top of the TV whose area is smaller than the bottom area of
the speaker. The speaker may fall and might cause personal injury.
the speaker. The speaker may fall and might cause personal injury.
●
Though this speaker is a magnetically shielded type, there may be some influence on a
TV picture depending on the type of TV or the placement of the speaker. In such a case,
place the speaker apart from TV so that there is no influence on TV picture.
TV picture depending on the type of TV or the placement of the speaker. In such a case,
place the speaker apart from TV so that there is no influence on TV picture.
Mounting the main and rear speaker
Mounting the center speaker
2