Yamaha O2R Manual Do Utilizador

Digital I/O, Setup, and Utilities

The 02R has 24 built-in analog input connectors; the individual input 
channels (MIC/LINE 1 through 16) and the stereo input channels (LINE 
17/18 through 23/24). You can route two of the 2-track digital inputs to the 
stereo input channels (2TR IN D1 to LINE 17/18 and 2TR IN D2 to LINE 
19/20). You can also convert the individual input channels (MIC/LINE 1 
through 16) to tape return channels, allowing you to perform 32-track 
mixdowns with the 02R.

Shown below is the DIGITAL I/O 2/5 page—Input Signal Select.

There are four boxes on this page.

The first box is for MIC 1-8 (MIC/LINE 1 through 8). You can select “CARD 
SLOT 3” or “INT ANALOG” (the default). If there is no digital I/O card in 
slot 3, the selection will fail.

The second box is for MIC 9-16 (MIC/LINE 9 through 16). You can select 
“CARD SLOT 4” or “INT ANALOG” (the default). If there is no digital I/O 
card in slot 4, the selection will fail.

The third box is for LINE 17/18. You can select “BUS 1/2”, “2TR-IN D1”, or 
“INT ANALOG” (the default). If there is no digital signal (no wordclock 
present) at the 2TR IN DIGITAL connector #1, the selection will fail.

The fourth box is for LINE 19/20. You can select “BUS 3/4”, “2TR-IN D2”, 
or “INT ANALOG” (the default). If there is no digital signal (no wordclock 
present) at the 2TR IN DIGITAL connector #2, the selection will fail.