Yamaha O2R Manual Do Utilizador
206
Digital I/O, Setup, and Utilities
02R User’s Guide
Input Patching
The Input Patching function allows you to select the signal sources for
MIC/LINE channels 1 to 24 and TAPE channels 1 to 16. The same source
can be selected for several channels. Bus outs can be patched through to the
TAPE channels for bus out monitoring and subgrouping. To prevent a
feedback loop, you cannot select bus outs to which a channel is routed, or
route a channel to the bus selected as its signal source. In either case a
warning message appears.
MIC/LINE channels 1 to 24 and TAPE channels 1 to 16. The same source
can be selected for several channels. Bus outs can be patched through to the
TAPE channels for bus out monitoring and subgrouping. To prevent a
feedback loop, you cannot select bus outs to which a channel is routed, or
route a channel to the bus selected as its signal source. In either case a
warning message appears.
Shown below is the TAPE 1–8 page of SCENE 4/5. On this page you can
select a card input from 1 to 8 or the corresponding bus out for TAPE
channels 1 to 8.
select a card input from 1 to 8 or the corresponding bus out for TAPE
channels 1 to 8.
Shown below is the TAPE 9–16 page of SCENE 4/5. On this page you can
select a card input from 9 to 16 or the corresponding bus out for TAPE
channels 9 to 16.
select a card input from 9 to 16 or the corresponding bus out for TAPE
channels 9 to 16.
In 24bit MODE you cannot select individual
buses. If you attempt to select a bus, the
confirmation dialog box shown here appears.
Choose EXECUTE to assign all buses to the card
inputs.
buses. If you attempt to select a bus, the
confirmation dialog box shown here appears.
Choose EXECUTE to assign all buses to the card
inputs.
1.
Use the [SCENE
MEMORY] button to
locate the SCENE 4/5
page.
MEMORY] button to
locate the SCENE 4/5
page.
2.
Use the CURSOR buttons
to select an input icon,
and the (ENTER) button
to select that input
channel group.
to select an input icon,
and the (ENTER) button
to select that input
channel group.
You can also use the
[SEL] buttons to select
input channel groups.
[SEL] buttons to select
input channel groups.
3.
Use the CURSOR buttons
to select a signal source,
and the (ENTER) button
to set it.
to select a signal source,
and the (ENTER) button
to set it.
SCENE
MEMORY