Yamaha NS-C125 Manual Do Utilizador
E-
3
English
■ Using the NS-M125 as surround
speakers in a surround sound
system
system
The speakers can be mounted on a wall by using
the bracket attached to the speakers’ back panels.
the bracket attached to the speakers’ back panels.
Fasten screws into a firm wall or wall support as
shown in the figure below, and hang the holes on
the protruding screws.
shown in the figure below, and hang the holes on
the protruding screws.
Holes
Make sure that the screws are caught by a
narrow part of the holes securely.
narrow part of the holes securely.
26 mm
(1”)
WARNING:
•
•
Each speaker weights 2 kg (4.4 lbs). Do not
mount them on thin plywood or soft wall
surface material, as the screws may come out
of the flimsy surface, causing the speakers to
fall down and be damaged, or result in
personal injury.
mount them on thin plywood or soft wall
surface material, as the screws may come out
of the flimsy surface, causing the speakers to
fall down and be damaged, or result in
personal injury.
•
Do not fasten the speakers to wall with nails,
adhesives, or other unsound hardware. Long
term use and vibrations may cause them to fall
down.
adhesives, or other unsound hardware. Long
term use and vibrations may cause them to fall
down.
•
To avoid accidents resulting from tripping
over loose speaker cords, fix them to the wall.
over loose speaker cords, fix them to the wall.
Note:
You can also use the screw holes on the bottom of
the NS-M125 for installing the speakers on
commercially available speaker stands.
You can also use the screw holes on the bottom of
the NS-M125 for installing the speakers on
commercially available speaker stands.
• Before installing, please refer to the instruction
manual of the speaker stand.
NS-M125
Wall or wall
support
support
Tapping screw
(commercially
available)
(commercially
available)
Diam. 3.5 to
4 mm (1/8”)
4 mm (1/8”)
3 mm
(1/8”)
(1/8”)
Min.
20 mm
(3/4”)
20 mm
(3/4”)
60
m
m
m
m
(2-
3
3
/8
”)
A screw with a diameter
of 6 mm (1/4”) can be
used (Hole depth: 20
mm, 3/4”)
of 6 mm (1/4”) can be
used (Hole depth: 20
mm, 3/4”)