Yamaha WD83390 Manual Do Utilizador

Metering

DM1000 Version 2—Owner’s Manual

Operating Basics

Metering

This section describes how to check Input and Output Channel levels using the Meter pages
or an optional MB1000 Peak Meter Bridge.

1 Press the DISPLAY ACCESS [METER] button repeatedly until the Meter | Posi-

tion page appears.

This page enables you to set the metering position for Input and Output Channels.

INPUT section
This section enables you to select the metering position for Input Channel signals.

OUTPUT section
This section enables you to select the metering position for Output Channel (Aux Out
1–8, Bus Out 1–8, Stereo Out) signals.

2 Move the cursor to the desired parameter button in the INPUT or OUTPUT

section, then press [ENTER].

You can select one of the following three positions in each section.

• PRE EQ ..........................Immediately before EQ.

• PRE FADER ..................Immediately before the fader.

• POST FADER ...............Immediately after the fader.

3 Press the DISPLAY ACCESS [METER] button repeatedly until the page listed

below that contains the desired channels appears.

- CH1-32 page
- CH33-48 page

These pages display the Input Channel 1–32 levels and Input Channel 33–48 levels
respectively.

- CH1-48 page

This page displays the Input Channel 1–48 levels altogether.

- Master page

This page displays the Output Channel (Aux Out 1–8, Bus Out 1–8, Stereo Out) levels
altogether.

- Effect page

This page displays the internal effects processor 1–4 input and output levels altogether.

Tip: If an optional MB1000 Peak Meter Bridge is installed, changes on this page will be
reflected on the Input & Output Metering Position parameters on the Peak Meter Bridge.