Yamaha YSP-4100BL Manual Do Utilizador

■ Assembling the supplied cardboard 

y

• If a subwoofer with adjustable volume and crossover frequency 

controls is connected to this unit, turn it on, set the volume to 
about half way and then set the crossover frequency to the 
maximum as shown below.

You can select one of the following AUTO SETUP types 
depending on your purpose.

• It is normal for loud test tones to be output during the AUTO 

SETUP procedure. Make sure that there are no children around 
in the listening room while the AUTO SETUP procedure is in 
progress.

• Make sure that your listening room is as quiet as possible. For 

accurate measurement, turn off air conditioner or other devices 
that make noises.

• To achieve the best results possible, vacate your listening room 

until the AUTO SETUP procedure is completed so that you may 
not obstruct the path of sound beams.

• If there are curtains in your listening room, we recommend 

following the procedure below.
1. Open the curtains to improve sound reflection.
2. Run “BEAM OPTIMZ ONLY”.
3. Close the curtains.
4. Run “SOUND OPTIMZ ONLY”.

y

• To return to the previous screen while using SET MENU, press 

IRETURN.

Press ISETUP.
The remote control keys to be used and available 
operations in each step are displayed at the bottom of 
the screen.

y

• You can also start the “BEAM+SOUND OPTIMZ” 

procedure simply by holding down MINTELLIBEAM for 
more than two seconds. In this case, proceed to step 4.

(Beam optimization and sound optimization)
Use to optimize the beam angle, delay, volume, and 
quality so that the parameters best match your listening
environment. It is recommended that you should select 
this optimization feature in the following cases:
• If you make settings for the first time
• If the unit has been relocated
• If your listening room has been restructured
• If the objects in your listening room (furniture, etc.) 

have been rearranged

This menu takes about three minutes.

(Beam optimization only)
Use to optimize the beam angle so that the parameter 
best matches your listening environment.
This menu takes about one minute.

(Sound optimization only)
Use to optimize the beam delay, volume, and quality so 
that the parameters best match your listening 
environment. You must optimize the beam angle with 
“BEAM OPTIMZ ONLY” before starting “SOUND 
OPTIMZ ONLY”. It is recommended that you should 
select this optimization feature in the following cases:
• If you have opened or closed the curtains in your 

listening room before using this unit

• If you have manually set the beam angle. 
This menu takes about three minutes.

;MEMORY

;AUTO SETUP

;MANUAL SETUP

;SOUND SET MENU

;SOUND OUT MENU

;INPUT MENU

;DISPLAY MENU

[ ]/[ ]:Up/Down
[ENTER]:Enter

SET MENU

.

p

p

I

G

M

GENTER

G

 / 

IRETURN

ISETUP

MINTELLIBEAM