Escalade Sports 2l-6231-05 Manual Do Utilizador

4

Figure 1

Figure 2

Figure 3

2. Attach two leg posts #3 inside each metal leg facade

#1 using two carriage bolts #30, two washers #22,
and two locknuts #21 for each leg post in the leg
facade. Make sure that the two holes that are closer
together are at the top of the wooden posts. There
will be approximately 1/8 inch that will extend
below the metal facade.  (Figure 2)  Once the leg
post is securely fastened, tighten the four bottom
screws #33 on the leg panels.

1. Begin by opening hardware kit #1 (P/N 5A-6133-00).

Attach two wooden leg panels #2 to the inside of leg
facade #1 using six screws #33, six washers #35, and six
locknuts #34, per leg facade.  Make sure that dimension
B (see illustration above) is at the bottom of the leg
panel.  (Figure 1)  NOTE: Leave all four bottom
screws #33 loose until the leg post #3 is installed.

3. Now open the rail carton.  Attach the wooden

beam #4 by using two long bolts #27, two short
bolts #40, six washers #23, and four locknuts
#26 as shown below.  The two longer bolts #27
go in the top and bottom holes and the two
shorter #40 bolts go in the two outside holes.
Place a washer between the wooden leg and the
locknut on the two longer bolts #27.  (Figure 3)