Escalade Sports 2l-6540-00 Manual Do Utilizador

Detail A

Figure 30

70. Attach pockets to rails by using five nails per pocket. Place nails

about ½ inch below the top of pocket so the balls will not hit nails

and get chipped. Hold the nails with a pair of needle nose pliers

(See Figure 29, Detail B) and tap them into the plastic pocket with

a small hammer.

HINT:

Hammer nails in until the heads are flush with the plastic pocket.

To do this you may want to use a nail or nail set to help drive nail

in (See Figure 29, Detail A).

71. After the pockets are secured, check to make sure all ball return

tubes are engaged in the pocket openings and the ball return

tubes are tilting toward the tray. Now take a ball and roll it down

both sides of the ball return system to check that the balls will

properly roll into the tray.

NOTE: If balls fall from ball tray, go back to

step 59-62.

72. Place playfield spots #47 on table as shown in figure 30 below.

73. A day later the table may have settled so check the levelness of the table the same way

you did in steps 12 and 13. If the table is not level raise the low corner by shimming up

that corner's leg.

Figure 29

Detail B

2L-6540-00