Escalade Sports m01475 booklet Manual Do Utilizador

Figure 1

F or C ustomer S ervice C all 1-888-996-2729

1. Find a clean, level place to begin the assembly of your game table. We

recommend building the unit on the box top to protect the parts during
assembly.

2. Place the main cabinet P1

up side down as shown in FIGURE 1.

3. Attach the goalie handle P3 to the main cabinet using bolt H2, two washers

H4 and lock nut H3. Do not over tighten, the handle must be able to pivot.

4. Attach the puck catcher P2 to the cabinet using screws H1 as shown in

FIGURE 1.

5. Repeat steps 3 and 4 for both ends of the table.

P10

P11

Figure 2

6. From the bottom of the table insert a gear assembly P10 into each player

groove. You want the playfield between the two flat tabs on the gear. You
do this by putting the tabs into the player groove and then turning the entire
gear assembly so it faces the rod it will be attached to. See Rod Assemby
Detail.

7. See FIGURE 2 for player rod layout.

8. Next push the gear assembly into the corresponding rod and attach with

screw H1. Also attach the rod stopper P11 to the rod with screw H1.

9. Slide one rubber bushing P9 onto each rod from outside of the main cabinet.

Slide a rod handle P8 on the rod after the rubber stopper.

Bushing