Echo CS-510 Manual Do Utilizador
8
PREPARATION FOR USE
Bar hole
Clutch cover
Adjusting screw
NOTE
Ensure that the chain is installed with the cutters
directed forward on the top of the bar.
directed forward on the top of the bar.
CAUTION
•
All adjustment, should be made cold.
•
Always wear gloves when working on chain.
Proper tension
Improper tension
MOUNTING GUIDE BAR AND
CHAIN
•
Unscrew two nuts and remove clutch cover.
•
Install the spiked bumper on the front of
machine. (Use two bolts 5
machine. (Use two bolts 5
×
12)
•
Mount bar and slide toward clutch to make saw
chain installation easier.
chain installation easier.
•
Install saw chain as shown.
(Ensure cutters are pointing in the right direction)
(Ensure cutters are pointing in the right direction)
•
Install the clutch cover tighten nuts finger tight.
Ensure that chain tension adjuster fits into bar
hole.
Ensure that chain tension adjuster fits into bar
hole.
Two bolts 5
×
12
Spiked bumper
ADJUSTMENT, CHAIN TENSION
•
Hold the bar nose up and turn the adjuster
clockwise until the chain fits snugly against the
underside of the bar.
clockwise until the chain fits snugly against the
underside of the bar.
•
Tighten both nuts with the bar nose held up.
•
Start the engine and run at low speed.
Stop and readjust if necessary.
Stop and readjust if necessary.