Sanyo POA-MD13NET2 Manual Do Utilizador
15
Network Board
OWNER’S MANUAL
ENGLISH
Connection of LAN cable
To connect to the network, it is required to use the UTP (Unshielded Twisted Pair)
strait cable with RJ-45 plug. There are two different types of cables depending on
whether the network is constructed with 10Base-T or 100Base-TX. Prepare the Hub
(10Base-T or 100Base-TX) to distribute the network cable if required.
strait cable with RJ-45 plug. There are two different types of cables depending on
whether the network is constructed with 10Base-T or 100Base-TX. Prepare the Hub
(10Base-T or 100Base-TX) to distribute the network cable if required.
✐ Use the UTP cross cable when you connect the computer and projector directly not using the
hub.
✐ When you connect the projector into the 10Base-T network, use cable with category 3 or 5.
When you connect the projector into the 100Base-TX network, use cable with category 5.
✐ The length of cable between hub and projector should be less than 100m.
1
Turn the Mains switch off.
2
Wind the UTP straight cable once
around the ferrite core (supplied)
as the illustrated below.
around the ferrite core (supplied)
as the illustrated below.
3
Connect the UTP straight cable to the LAN port on the network board.
4
Connect the UTP straight cable to the hub.
WARNING
TEMP.
READ
Y
LAMP
REPLA
CE
LAMP
Hub
(10Base-T, 100Base-TX)
(10Base-T, 100Base-TX)
UTP straight cable
Projector
Ferrite Core
Mains Switch
Connection of LAN cable