Sanyo POA-MD13NET2 Manual Do Utilizador
14
Chapter 2 Installation
x Installation and Network configuration
Mounting
1
Turn the Mains switch off.
2
Remove 2 screws on a board
from any of the slots 1 to 4, and
then pull the board out from the
projector.
from any of the slots 1 to 4, and
then pull the board out from the
projector.
3
Put the Board into the board slot
along the guide. Mount the
board connector into the socket
in the slot firmly.
along the guide. Mount the
board connector into the socket
in the slot firmly.
4
Secure the board with two screws
(supplied).
(supplied).
✐ Mains switch must be turned off when mounting or removing this product otherwise it may
damage the product.
✐ Do not install multiple network boards into a projector otherwise it may damage the product.
✐ Do not connect the AC cord until after connecting the LAN cable and computer.
Caution
!
WARNING
TEMP.
READ
Y
LAMP
REPLA
CE
LAMP
Guide
Mains Switch