Sanyo POA-MD13NET2 Manual Do Utilizador
64
Chapter 6 Use of Serial Port
Control the projector with Telnet
This product allows you to control the projector by using the Telnet application.
Normally, it is used to control the external equipment connected to the serial port and
also control the projector itself by specifying the telnet port no.10000.
Normally, it is used to control the external equipment connected to the serial port and
also control the projector itself by specifying the telnet port no.10000.
Specify port no. 10000 as the right on the
serial port setting page. This function
does not depend on other setting items.
serial port setting page. This function
does not depend on other setting items.
In the setting of the computer, specify
the port no. 10000 at the procedure 3 on
the previous setting example page as the
below.
the port no. 10000 at the procedure 3 on
the previous setting example page as the
below.
Host name
: 192.168.0.2
(type a projector IP address)
(type a projector IP address)
Port
: 10000
Terminal type
: vt100
After established the communication, type the
password and the command for controlling the
projector and then enter the “Enter” key.
The right table shows the typical command lists
for controlling our projectors and please consult
your local dealer for further information of anoth-
er commands.
password and the command for controlling the
projector and then enter the “Enter” key.
The right table shows the typical command lists
for controlling our projectors and please consult
your local dealer for further information of anoth-
er commands.
Command
Function
C00
Turn the projector on
C01
Turn the projector off
C05
Selects SLOT1
C06
Selects SLOT2
C07
Selects SLOT3
C08
Selects SLOT4*
C09
Volume up
C0A
Volume down
C0B
Mute on
C0C
Mute off
C0D
Video mute on
C0E
Video mute off
C1C
Menu display on
C1D
menu display off
Command list table
* Only effective for the 4 slots model.