Sanyo POA-MD13NET2 Manual Do Utilizador

Status

If some of the registered projectors are
deactivated by some reasons (such as
disconnecting the power source, discon-
necting the LAN cable, disconnecting
from the network), control changes will
continue to be effective for the projec-
tors that are still activated. At the same
time, the deactivated projectors are
excluded from the multi-control. The
status of the registered projectors are
indicated under the projector name. See
the table below for status indications.

Exclude/Add/Delete a projector

To change the mode of the registered
projectors, select a mode with the pull-
down menu button under the IP address
of the target projector and then click Set
button.

OFF ....................Excluding from the multi-control
ON ....................Adding to the multi-control
Delete ..................Deleting from the multi-control

(blank)................The projector is connected to the network correctly
No connection ........The projector may not connect to the network. Please check the connection and net-

work configuration of this projector.

Password error ......The login password is incorrect. The password for the multi-controlled projectors

must be the same. Change password of this projector to the common password.

✐ If the multi-controlled projector is in the standby mode, any change is not effective except

timer setting.

✐ It is recommended that a specified projector should be chosen for setting as a master when

you use this multi-control function. The control for the multi-controlled projectors will become
too complicated operation if this function is used for each projector.

✐ If the registered projector is not connected to the network, it will take some time to complete

the multi-control operation because of waiting for the response from each registered projec-
tor.

Status display