Yamaha EG-112C Manual Do Utilizador

6

When changing strings it is necessary to cut off the ball ends 
of the strings.
Following is the procedure for changing strings and adjusting 
the vibrato system:

1)  Using the supplied hexagonal wrench, loosen the three hex-

agonal screws on the lock above the nut. (illustration — A)

2) Loosen the individual string locks using the supplied hex-

agonal wrench. (illustration — B)

3)  Replace the old strings with new strings.

4)  Using the hexagonal wrench, lock each string. 
 

(illustration — B)

 

After locking the strings, make sure that the fine tuning 
thumb screws are in the middle of their range of travel. (il-
lustration — C)

5)  Tune the guitar to the correct pitch.

6)  Remove the back plate to gain access to the vibrato strings. 

Three springs are factory installed and we recommend that 
these springs be adjusted so that the vibrato bridge plate 
is parallel to the top of the guitar when it is tuned to correct 
pitch.

7)  Lock the strings above the nut. (illustration — A)

8)  Use the fine tuning thumb screw to tune the guitar to the 

correct pitch. (illustration — C)

Tighten   

Loosen

01_e_g_om_en.indd   6

01_e_g_om_en.indd   6

09.3.13   9:41:41 AM

09.3.13   9:41:41 AM