Tektronix 2200 Manual Do Utilizador

2-1

This section describes turning on the system, setting up user 
preferences, and setting up system parameters.

The Model 2200 is designed for continuous operation. Use the 
following procedures to power-up the switcher when it has been 
turned off.

1.

Turn the power switch on the front of the Signal Processor 
Power Supply to the ON position. Verify that the power 
supply voltage LEDs on the front of the Power Supply are lit 
and that the fans in the Processor are on.

2.

Raise the Control Panel and turn the power supply switch to 
the ON position. Verify that the green 

 on the CPU 

Board (located in the middle of the tub) is lit.

3.

Verify that the Model 2200 sign-on logo is displayed on the 
Menu Display.

4.

Verify that the panel pushbutton lamps are on and that the 
E-MEM and Transition subpanel readout LEDs are on.

If any of the above conditions are not present, turn the system 
power off and refer to the Diagnostics and Troubleshooting 
section in the Installation and Service manual.

2