Sub-Zero dualfuel install guide Manual Do Utilizador

W O L F  

R A N G E O P E R A T I O N

IMPORTANT NOTE: Prior to operating the
range, be sure to read the entire Wolf Dual
Fuel Ranges Use & Care Information included
with the range for important safety, service
and warranty information.

Install the oven rack guides onto the shoulder
screws located on the interior side walls of the
oven. Slide the oven racks onto the support
racks within the oven. There are three racks
per oven, except for the 18" (457) oven which
has two racks. Place the broiler pan and grid
on a rack within the oven, if desired.

Turn on the power supply to the range. The
control panel should be closed (no visible
control pads). Touch and slightly depress the
flame graphic on the hidden control panel to
open.

Set the time of day by pressing the CLOCK
touch pad, scroll to the desired time by using
the up or down arrows, then touch ENTER.
After setting the time, the hidden control panel
can be closed. The control panel does not have
to be open to operate the oven.

Select any of the eight cooking modes by
using the oven control knob bezel and turning
to the desired mode. Once the mode has been
selected, the temperature can be adjusted by
turning the temperature readout knob clock-
wise to increase the temperature or counter-
clockwise to decrease the temperature. Verify
that the oven is coming up to temperature. For
a 48" (1219) or 60" (1524) range, follow this
procedure for the both ovens.

IMPORTANT NOTE: A small amount of
smoke and odor may be noticed during the
initial break-in period. Refer to the Use & Care
Information for additional information.

T H E R A N G E

If removing the dual fuel range is necessary for
cleaning or service, shut off the gas supply.
Disconnect the gas supply and electrical
connections to the unit, then remove the
range. Reinstall in the reverse order and be
sure to check the gas connection for leaks.

Refer the Wolf Dual Fuel Ranges Use & Care
Information included with the range for
cleaning recommendations.