Ariens 911111 - SSP 21LM Manual Do Utilizador
GB - 12
Standard Models
To change cutting height, move cutting height
levers one notch at a time on each wheel to
set desired height (Figure 7).NOTE: Each wheel on mower must be set at
the same height for a level cut.
levers one notch at a time on each wheel to
set desired height (Figure 7).NOTE: Each wheel on mower must be set at
the same height for a level cut.
OPTIONAL CONTROLS
Primer Bulb
Push the primer bulb in to add fuel for easier
engine start.
engine start.
Wheel Drive Control
(self-propelled
models)
NOTE: Engine must be running for wheel
drive to propel unit.
drive to propel unit.
911111
To drive forward:
Slowly squeeze the wheel drive control
toward the handlebar until you reach a
comfortable ground speed. Hold the wheel
drive control against the handlebar for full
speed.
To stop:
toward the handlebar until you reach a
comfortable ground speed. Hold the wheel
drive control against the handlebar for full
speed.
To stop:
Release wheel drive control.
Cutting Height Settings Chart
Notch
Cut grass length
1
1" (25 mm)
2
1-1/4" (32 mm)
3
1-1/2" (38 mm)
4
2-1/4" (57 mm)
5
2-3/4" (70 mm)
6
3-1/2" (89 mm)
7
4" (102 mm)
High
High
Low
Figure 7
1. Cutting Height Lever
1
1
Front
Rear
Low
High
Low
CAUTION: Unit will move forward
at engine start if wheel drive
control is engaged. ALWAYS
release wheel drive control before
starting unit.
at engine start if wheel drive
control is engaged. ALWAYS
release wheel drive control before
starting unit.
STOP
GO
OM1245
GO
Figure 8