Oricom p80 Manual Do Utilizador

 
 

 

 

17

You cannot program the base ringer if the handset has lost link with the base.  
UNAVAIL will be displayed.  Re-establish the link and try again. 
 
Recall duration 
When you are talking on the phone, pressing     will send a flash signal.  

Recall settings are; Australia (Recall 1)100ms and New Zealand (Recall 2) 
600ms. You should not need to change these settings.  
Press  

  during standby and press  

  until you see   flashing.  

1. Press 

 

  to select. The current duration is now displayed. 

2. Press 

1 or 2 directly or press  

  to select. 

3. Press 

  to confirm. 

 
Register 
Each handset can register to one base at a time only.  The current base will 
be deregistered when a new base is registered. 
Each base can register up to 

4

 handsets. 

1. Press 

 

  during standby and press     or     until you see  icon 

flashing.  

2. Press 

  to select.    

3.  Before you enter the PIN, press and hold 

  on the base for 

2

 seconds 

until a registration tone is emitted. The base is now in the registration 
mode.  (If the base is full and cannot take on any more handset, it will 
emit a reject tone instead.  See the section of Deregister to delete a 
currently registered handset.) 

4.  Enter the PIN of the base and press 

 . 

You will hear a confirmation tone if the registration is successful.  The 
handset label and the handset number will be displayed. 
If the registration is not successful, you will see NOT REG on the handset.  
Follow the procedure and try again. 
 
Deregister 
A handset can deregister another handset registered to the same base.  It 
cannot deregister itself. 
1. Press 

 

  during standby follow by the 9 key. 

2.  Enter the handset number (i.e. HS#2) to delete. The LCD will display 9-2. 
3. Press 

  and then  

4.  Enter the PIN  
5. Press 

  to confirm.