Sharp AR-5316 Manual Do Utilizador

Página de 80
53
5
REPLACING THE TD CARTRIDGE
When the TD cartridge replacement required indicator (
) lights up, the TD cartridge will need replacement soon. 
Obtain a new cartridge. When the TD cartridge replacement required indicator (
) blinks, the TD cartridge must 
be replaced before copying can be resumed.
Replace the TD cartridge by following the procedure below.
1
Push on both ends of the front cover 
and open it.
2
Pull the TD cartridge out while pulling 
up on the lock release lever.
Pull out the TD cartridge 
until the green strap 
handle can be grasped. 
While supporting the TD 
cartridge at the green 
label with your left hand, 
grasp the green strap 
handle with your right 
hand and pull the TD 
cartridge all the way out.
3
Remove the new TD cartridge from the 
bag. Grasp the cartridge on both sides 
and shake it horizontally four or five 
times.
4
Remove the protective cover from the 
TD cartridge by unlatching three 
cover hooks from the holes on the 
cartridge and then pulling the cover in 
the direction indicated by the arrow in 
the illustration.
5
Insert the TD cartridge along the 
guides until it locks in place.
If there is any dirt or dust 
on the TD cartridge, 
remove it before 
installing the cartridge.
When the TD cartridge replacement indicator (
) lights up, little toner remains and thus copies may be faint.
Note
After removing the TD cartridge, do not shake 
it or tap on it. Doing so may cause toner to 
leak from the cartridge. Put the old cartridge 
immediately in the bag contained in the box of 
the new cartridge. Dispose of the old TD 
cartridge in accordance with local regulations.
TD cartridge
lock release lever
Caution
4 or 5 times
AR-5316-5320-EX.book  53 ページ  2005年4月8日 金曜日 午前9時35分