Epson MX-70 Manual Do Utilizador

The MX-70 is designed to interface directly with parallel printer computers like
the Apple II and the TRS-80 Models I, II, and III. RS-232, IEEE 448, and other

interfaces are not factory supported. There is no provision for installing inter-
face boards inside the case.

The following table identifies known cables which are wired correctly for use with the
MX-70:

Apple II

Apple III

EPSON I/F P/N 8131

EPSON Cable P/N 8230
‘Apple Centronics Parallel I/F

Same as above
Run in Apple II emulation

Atari 400

Atari 800

Atari 400/800

(with 850 I/F)

TRS-80 Model I

(without expansion I/F)

TRS-80 Model I

(with expansion I/F)

TRS-80 Model II

TRS-80 Model III

2Macrotronics P/N A4P-3

2

Macrotronics P/N A8P-3

Macrotronics P/N A85OE

Radio Shack P/N 26-1411

Epson Cable P/N 8220
3Radio Shack P/N 26-1401

Radio Shack P/N 26-4401

Epson Cable P/N 8220
3Radio Shack P/N 26-1401

‘Requires Modification to ground the Most Significant Bit

Kontact Macrotronics for additional information
3Cut Pin #35 at the printer end of the cable

95