Tektronix mtg100, mtg300 Manual Do Utilizador

Replacing the Hard Disk Drive(s)

6Ć72

MTG100 & MTG300 MPEG Generator Service Manual

Data Hard Disk Drives

Before removing the data hard disk drives, you should save all the transport
stream, insertion, and preset files (except for the factory-supplied files) stored on
the data hard disks to the hard disk on the PC.

Perform the following steps to upload a transport stream file, insertion file, or
preset file from the MPEG generator to the PC:

. Refer to the Appendix B: Using MTG Comm

+

 for File Transfer in the

MTG100 & MTG300 MPEG Generator User Manual for setting the Ethernet
network parameters and operating the MTG Comm

1. Connect your PC and MPEG generator using a 10BASE-T crossover

Ethernet cable, and then set the Ethernet network parameters for the MPEG
generator and MTG Comm

+

 application.

2. Start the MTG Comm

+

 application.

3. In the List view of the MTG Comm

+

 application, select the file you want to

upload to the PC.

4. Select MTG to PC... from the File pull-down menu to open the Save As

dialog box.

5. In the Save As dialog box, specify the destination folder for the file you are

going to upload to your PC.

6. Click the Save button to upload the file from the MPEG generator to your

PC.

7. Repeat steps 3 through 6 as required until you have backed up all the files

you want to save.

Before installing the new data hard disk drives into the MPEG generator, you
should set the configuration jumpers of the disk drives.

If you use the hard disk drives listed in the Replaceable parts list in Section 10
(Tektronix p/n 119-B084-XX), disconnect all the jumpers from the connector pin
located on the back of the drive.

Backing up the Files

Stored on the Data Hard

Disks

Setting the Jumpers

before Installation