Tektronix mtg100, mtg300 Manual Do Utilizador
Installation
2Ć4
MTG100 & MTG300 MPEG Generator Service Manual
Applying and Interrupting Power
Consider the following information when you power on or power off the MPEG
generator, or when external power loss occurs.
generator, or when external power loss occurs.
Connect the proper power cord from the rear panel power connector to the power
system. Refer to Table 2-2 for power cord identification.
system. Refer to Table 2-2 for power cord identification.
Apply power to the standby circuit of the instrument by pushing the
PRINCIPAL POWER SWITCH on the rear panel of the instrument. Refer to
Figure 2-1.
PRINCIPAL POWER SWITCH on the rear panel of the instrument. Refer to
Figure 2-1.
. After the instrument is installed, leave the PRINCIPAL POWER
SWITCH on and use the ON/STBY switch as the power switch.
SWITCH on and use the ON/STBY switch as the power switch.
Figure 2Ć1: Rear panel power connector and power switch
Connect Power Cable
Standby Power