Snapper uv1621bv Manual Do Utilizador

21 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 
3.2.3.  Check Transmission Fluid Level 

1.  Raise empty cargo bed and secure with prop rod. 
2.  Remove dipstick from top of transmission and 

wipe clean. 

3.  Screw dipstick fully back into transmission. 
4.  Remove dipstick and check fluid level. 
5.  Add MOBILFLUID 424 to bring level to “Full” 

mark on dipstick. Install dipstick and tighten 
securely 

6.  Lower cargo bed and latch securely. 

1.  Use a low pressure gage to measure tire inflation 

pressure. 

2.  Adjust tire pressure to 15 psi. front and rear.  Do 

Not over inflate. 

 

1.  Park machine on level surface. 
2.  Release park brake. 
3.  Locate grease fitting on left axle coupling. See 

Figure 3.4. 

 

 

 

 
 

4.  Roll machine until grease fitting is accessible. 
5.  Apply (2) shots of General Purpose grease from a 

grease gun 

6.  Repeat on right axle coupling. 
7.  Locate grease fitting on left & right king pins.  See 

Figure 3.4a. 

8.  Apply (4) shots of General Purpose grease from a 

grease gun. 

 

 

 

 

1.  Torque all lug nuts to 75 ft-lb. 

1.  Move machine to an open area, free of obstacles, 

children and others. 

2.  Set park brake firmly (2 or more clicks). 
3.  Start engine and shift transmission to Forward. 
4.  Using caution, gently move accelerator pedal to 

approximately 1/2 speed. Hold pedal 
momentarily. 

5.  Machine should not move.  Release accelerator 

pedal and allow engine to return to idle. 

6.  Shift transmission to Reverse. 
7.  Move accelerator pedal to approximately 1/2 

speed.  Hold pedal momentarily. 

8.  Machine should not move.  Release accelerator 

pedal and turn engine off. 

9.  If machine moved, Refer to Section “Adjustments 

– Service Brake and Park Brake”. 

 

23