Snapper uv1621bv Manual Do Utilizador

25 

8.  Operate machine on smooth flat surface at 

approximately 1/2 speed. 

9.  Apply brake firmly.  Machine should stop in a 

straight line and not pull to either the right or the 
left.  Also both rear tires should begin to skid 
evenly. 

10.  If the machine pulls to the left or the left tire skids 

before the right, tighten the right brake adjustment 
nut 1/4 turn clockwise. 

11.  If the machine pulls to the right or the right tire 

skids before the left, tighten the left brake 
adjustment nut 1/4 turn clockwise. 

12.  Continue until the machine stops straight and both 

tires skid evenly. 

NOTE: The battery in this machine is maintenance-free.  
It has been filled to the proper level with acid and is 
sealed.  Do not attempt to open the battery. 

1.  The battery is located under operator’s seat. 

Remove seat knobs and carefully tilt forward to 

expose battery. See Figure 4.3. 

 

 

 

2. Observe and note cable positions on battery.  

See Figure 4.4. 

3. 

Disconnect cables from battery terminals, 
disconnecting BLACK (Negative) cables first.  
Retain hardware.  

 
 
 
 

 

 

 

4.  Remove battery retaining strap hardware and 

carefully lift battery out of battery tray. See 
Figure 4.4. 

 

Cables must be connected to battery terminals in the 
proper position as shown in Figure 4.4. DO NOT 
attempt to charge battery while installed on the 
Machine.  DO NOT use “BOOST” chargers on the 
battery. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

27