Thermador SEMW302 Manual Do Utilizador
36
SEM/SEMW Oven Care and Use Manual
Problem Solving / Consumer Service
Solving Operational Problems
Before calling for service, check the following to avoid unnecessary service charges.
PROBLEM
PROBLEM SOLVING
OVEN
STEPS
All the numbers touched
The numbers were touched too rapidly. Be sure you remove your finger do
not appear in display
from the number pad before touching the next digit.
F followed by 2 digits
Touch OVEN OFF or turn power off at the circuit breaker, wait 3 minutes
appears in the display
and turn it back on. If condition persists, note the code number and call
window
an authorized servicer.
F-24 or F-25
This is caused by close contact to the control panel for more than 60 seconds,
appears in display window
such as someone leaning against the controls or objects hanging in front of
controls. See item above for correction.
controls. See item above for correction.
S A b
appears in
Turn off the oven selected by touching OVEN OFF.
display window
Cooling fan continues to run
The fan turns off automatically when the electronic components have
after oven is turned off
cooled sufficiently.
Clock and timer
Make sure there is proper electrical power to the oven.
do not work
See the Clock and Timer sections on Pages 12 & 13.
Oven will not work
Make sure there is proper electrical power to the oven.
Check the circuit breaker or fuse box to your house.
Check the circuit breaker or fuse box to your house.
Oven light does
Replace or reinsert the light bulb if loose or defective. See Page 33.
not work
Touching the bulb with your fingers may cause the bulb to burn out
quickly. Oven light does not work if Self-Clean mode is set.
quickly. Oven light does not work if Self-Clean mode is set.
Oven temperature is
The oven thermostat needs adjustment. See Calibrating Oven
too hot or too cold
Temperature in Do-It-Yourself Maintenance, Page 34.
Oven will not self-clean
The oven temperature is too high to set the self-clean operation.
Allow the oven to cool to room temperature and reset the controls.
Be sure you have touched Self-Clean.
Allow the oven to cool to room temperature and reset the controls.
Be sure you have touched Self-Clean.
Oven door will not
Allow the oven to cool below the locking temperature.
unlock
Oven is not clean
Heavily soiled ovens may need to self-clean again or for a longer
after the clean cycle
period of time. Heavy spillovers should be cleaned before starting
the clean cycle. See Before You Self-Clean,
the clean cycle. See Before You Self-Clean,
Page 28.
Oven does not lock in
Do not run Self-Clean. Call for service. See Page 34.
Self-Clean mode