Alliance Laundry Systems 70400401r2 Manual Do Utilizador
Operation
13
70400401
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
DMP OPL Features
DIP Switch Settings
The DMP has an 8 position DIP switch bank that is
accessible from the back of the control board. By
switching these DIP switches, it is possible for the
operator to customize the display and some of the
operating features of the tumbler.
accessible from the back of the control board. By
switching these DIP switches, it is possible for the
operator to customize the display and some of the
operating features of the tumbler.
DIP Switch Functions Explained
1. Tumbler Type: This DIP switch selects the type
of tumbler, i.e., OPL or Coin.
2. Temperature Units: Selects ºF or ºC for the
temperature display. Factory setting is for ºF.
3. Local/Remote Reversing: Preset at the factory;
usually for local reversing. Remote reversing for
use with Reversing Timer Board only.
use with Reversing Timer Board only.
4. Empty: Preset at the factory; always ON.
5. Empty: Preset at the factory; always ON.
6. Buzzer Timer: This DIP switch determines the
length of time that the end of cycle buzzer will
remain on. “OFF” indicates that the buzzer will
sound for 5 seconds when the drying cycle is
completed. “ON” indicates that the buzzer will
sound continuously until the STOP button is
pressed, or the loading door is opened.
remain on. “OFF” indicates that the buzzer will
sound for 5 seconds when the drying cycle is
completed. “ON” indicates that the buzzer will
sound continuously until the STOP button is
pressed, or the loading door is opened.
7. Safety Tumble, Display Count, or Pay: If DIP
switch #1 is set for OPL, then DIP switch #7 in
the ON position enables the safety tumble. If DIP
switch #1 is set for Coin, then DIP switch #7 in
the display of “PAy,” to indicate that coins are
needed to run the tumbler.
the ON position enables the safety tumble. If DIP
switch #1 is set for Coin, then DIP switch #7 in
the display of “PAy,” to indicate that coins are
needed to run the tumbler.
8. Programming: This switch enables or disables
the programming feature and should normally be
in the OFF position.
in the OFF position.
Function
OPL
Coin
1
Tumbler Type
OFF
ON
OPL=Off; Coin=On
2
Temperature Units
OFF
OFF
ºF=Off; ºC=On
3
Local/Remote
Reversing
ON
ON
Local=On; Remote=Off
4
Empty
ON
ON
Always ON
5
Empty
ON
ON
Always ON
6
Buzzer Timer
ON
ON
5 Sec=Off; Continuous=On
7
Safety Tumble (OPL)
or Coin Count/Pay
(Coin)
ON
OFF
#1
#7
DIP SWITCH
OFF
ON
SAFETY TUMBLE
OFF
OFF
NO SAFETY TUMBLE
ON
ON
COIN COUNT
ON
OFF
PAY
8
Programming
OFF
OFF
Disable=Off; Enable=On
Table 2