SMART Technologies 600i3 Manual Do Utilizador

CHAPTER 6 – TROUBLESHOOTING YOUR SMART BOARD 600I 3 OR SBD600I3 
INTERACTIVE WHITEBOARD SYSTEM

 

System Warning Lights 

ECP Ready Light and System Status

The ECP ready light is located on the ECP’s main power button. This button also 
functions as your status warning light. 

Projector Ready Lights and Projector Status

The UF55/UF55w projector’s two indicator LED lights (Power and Temperature) are 
located on the boom-mounted projector. Specific light sequences convey information 
about the state of your projector, including warning messages and issues. 
The following table describes projector warning messages and issues.

IMPORTANT
After you resolve your projector’s issue, you must disconnect and then reconnect 
your projector power cable, clear the indicator light sequence, and then reset your 
projector’s status.

Off

The projector system isn’t receiving power. Check your 
power cord, RS-232 connector at the projector (located 
below the power cable) and power supply. If nothing 
changes after checking your power cord, RS-232 
connector and power supply, call your 

Solid amber

The projector is receiving power but is turned off. 

Flashing green

The projector is receiving power and is starting up.

Solid green

The projector is on and the ECP is receiving power and 
communicating with the projector.

Flashing amber

Your interactive whiteboard system is about to enter 
Idle mode.

Idle mode 

Solid Amber

Off

Powering

Flashing Green

Off

On (Lamp On)

Solid Green

Off

Cooling

Flashing Amber

Off